kia Workshop Repair Guides

Kia Workshop Service and Repair Manuals

A/C - Noise/Insufficient Cooling|Page 5111 > < A/C - Noise/Insufficient Cooling
Page 2
background image

^

Run the engine at 2,000 rpm, monitor high and low side pressures and record. Monitor the inside temperature dash vent gauge and record. See
pressure chart.

^

Normal gauge reading are approximately 21-28 psi on the low side (Suction) and 206-213 psi on the high side (Discharge). Pressure readings will
vary slightly depending on the ambient temperature and humidity levels.

* NOTICE

SERVICE PRECAUTIONS:

^

When working on A/C systems all equipment must be in good working condition and properly maintained.

^

All weight scales must be in working order and unobstructed to properly charge the A/C system.

^

All refrigerants must be recovered per Federal Law Clean Air Act, any residual refrigerant must be recovered and not released into the atmosphere.

^

Flushing of the A/C system may be required, prior to re-charging the A/C system dependent on contamination of the A/C system. Always flush the
A/C system after an internal compressor failure.

A/C - Noise/Insufficient Cooling|Page 5111 > < A/C - Noise/Insufficient Cooling