Sedona EX V6-3.5L (2002)
3.
Remove the splash shield from the sub-frame on the RH passenger side.
4.
Remove the bolt holding the power steering lines on the RH passenger's side.
5.
Detach the O2 sensor connector from the coolant pipes, then remove the (one) nut and (two) bolts that attach the coolant pipes to the body.
6.
Lower the vehicle leaving the drain pan in place to catch any additional coolant.
Remove the air filter assembly and intake hose to the throttle to access the area where the two heater hoses attach to the engine.
The hose connections are below the thermostat / ECT area.
Cut the two hoses just removed off of the original coolant pipe assembly as close to the coolant pipe connections as possible.
NOTICE:
This will aid in removing the coolant pipe assembly in the following steps.
8.
Cut the coolant hoses off of the heater connections as close to the heater core as possible.
Remove the clamps and remaining pieces of hoses from the heater core assembly.
CAUTION:
Take extreme care not to damage the heater core or its connections!
9.
Raise the vehicle on the lift.
