Sedona EX V6-3.5L (2002)
2. Connectors can be removed by pressing or pulling lock lever.
Locking a connector
Listen for a click when locking connectors. This sound indicates that they are securely locked.
How to Replace Terminals
Replacement of terminals
Use appropriate tools to remove terminal as shown.
When installing the terminal, insert it until it locks securely.
<Female>
Insert a thin piece of metal from the terminal side of the connector, and then, with the terminal locking tab pressed down, pull the terminal out of the
connector.
<Male>
Follow the same procedure as female-type terminal.
Test Light
Test Light
The test light, as shown in figure, uses a 12 V bulb. The two lead wires should be connected to probes. The test light is used for simple voltage checks
and in checking for short circuits.
