Sedona EX V6-3.5L (2002)
Fuel Pressure: Testing and Inspection
1. Reduce the internal pressure of the fuel pipes and hoses by the following procedures.
Disconnect the fuel pump harness connector in the rear seat side.
Start the engine and, after it stops by itself, turn the ignition switch to the OFF position. Disconnect the battery negative (-) terminal. Connect the
fuel pump harness connector.
2. Disconnect the fuel high pressure hose at the fuel line side.
CAUTION: Cover the pipe connection with a shop towel to prevent splashing of fuel caused by residual pressure in the fuel line.
3. Using the fuel pressure gauge adapter, install the fuel-pressure gauge to the fuel high pressure hose.
4. Connect the battery's negative (-) terminal.
5. Apply battery voltage to the fuel pump drive terminal, activate the fuel pump; then, with fuel pressure applied, check that there is no fuel leakage
from the pressure gauge or connection part.
