Sedona EX V6-3.5L (2002)
13.
When "REPROGRAMMING COMPLETED" message is displayed, turn ignition key to the "OFF" position and disconnect Hi-Scan Pro from the
vehicle. Wait at least 20 seconds, start vehicle and verify normal operation.
* NOTICE
If reprogramming did not complete properly or was interrupted, repeat the process using the following procedure.
MANUAL REPROGRAMMING PROCEDURE:
1.
Turn ignition key to the "ON" position.
2.
Turn Hi-Scan Pro on and select "14. SEDONA 3.5D 02103MY BATTERY DRAIN" and press the "ENTER" key.
3.
Select "02. SEDONA 02/03 MY BATT DRAIN [ERROR]" and press the "ENTER" key.