Sedona EX V6-3.5L (2002)
Seat Belt: Service and Repair
Lap/Shoulder belt assembly
Removal
1. Remove one bolt from mounting bracket and remove bracket.
2. Retract belt slowly as far as it will go.
3. Unsnap the captive shoulder belt anchor bolt cover from bottom and lift up.
4. Remove one anchor bolt.
5. Remove pillar lower trim.
6. Remove belt guide.
7. Remove one bolt and one sheet metal screw to remove retractor assembly.
Installation
1. Install one bolt and one sheet metal screw to attach the retractor assembly.
Tighten latch and bolts to : 14 - 19 lb.ft (1.9 - 2.6 N.m, 1.9 - 2.6 kg.m)
WARNING: EXERCISE CARE TO INSTALL THE BELT SO THERE ARE NO TWISTS IN IT. A TWISTED BELT MAY BE
HARMFUL TO A PASSENGER IN A SERIOUS ACCIDENT. A TWISTED BELT ALTERS THE DISTRIBUTION OF FORCE
RESULTING FROM SUDDEN DECELERATION.
2. Install two screws in belt guide.
3. Install pillar trim panel.
4. Install anchor bolt.
Tighten latch and bolts to : 14 - 19 lb.ft (1.9 - 2.6 N.m, 1.9 - 2.6 kg.m)
5. Install anchor bolt cover.
6. Install one bolt through lap belt mounting bracket.
Tighten bolt to : 14 - 19 lb.ft (1.9 - 2.6 N.m, 1.9 - 2.6 kg.m)
7. Install bolt cover.
