Sedona EX V6-3.5L (2002)
CAUTION: When checking the engine control module (ECM), never use a bulb exceeding 3.4 W.
Jumper Wire
Jumper Wire
The jumper wire is used for testing by shorting across switch terminals and ground connections.
CAUTION: Do not connect a jumper wire from the power source line to a body ground. Such a connection may cause damage to harnesses or
electronic components.
Voltmeter
Voltmeter
The DC voltmeter measures circuit voltage. A voltmeter with a range of 15 V or more is used by connecting the positive (+) probe (red lead wire) to the
point where voltage is to be measured, and the negative (-) probe (black lead wire) to a body ground.
Ohmmeter
Ohmmeter
The ohmmeter is used to measure the resistance between two points in a circuit and also to check for continuity and the diagnosis of short circuits.
