Sedona EX V6-3.5L (2002)
2. Install the suction hose on the power steering pump and install hose clamps.
3. Install the pressure hose and tighten bolt.
Tightening torque: 39.7 - 47.0 ft. lbs. (54.0 - 63.7 Nm, 5.5 - 6.5 kg-m)
Notice: Be sure hose clamps are properly reinstalled and suction hose is clear of all accessory drive belt.
4. Install the P/S belt to the power steering pump.
5. Adjust the belt deflection by turning the adjusting bolt.
Deflection (when applying 22 lbs., 98 N 10 kg)
New one: 0.35 - 0.43 inch (8.8 - 11 mm)
Used one (more than 5 minutes): 0.49 - 0.56 inch (12.5 - 14.3 mm)
Upon tension check: 0.46 - 0.60 inch (11.7 - 15.3 mm)
6. After making the adjustment, tighten the hinge bolt and the flange nut.
Tightening torque:
Hinge: 23.8 - 40 ft. lbs. (32.3 - 54 Nm, 3.3 - 5.5 kg-m)
Flange: 13.7 - 20.2 ft. lbs. (18.6 - 27.4 Nm, 1.9 - 2.8 kg-m)
Notice: In order to prevent the asymmetrical alignment of the tension pulley upon tension adjust, preliminary tight the hinge bolt and the flange
nut before adjusting tension.
7. Fill the steering pump reserve tank to correct fluid level.
8. Install cap on the power steering pump reserve tank.
9. Start engine and turn steering wheel several times from stop to stop to bleed air from fluid in system. Stop engine, check fluid level and inspect
system for leaks.
