Sedona EX V6-3.5L (2002)
-
Parts Information
-
Service Procedure
1.
Raise and properly support the vehicle.
2.
Remove the front tire and wheel assembly.
3.
Remove the two (2) Lower strut to upper steering knuckle bolts on each side.
4.
Disconnect the brake hose and ABS wheel speed sensor from the strut assembly.
NOTICE:
Note orientation of mount before removal from vehicle.
5.
Open hood and remove four (4) upper strut retaining nuts.
6.
Remove the strut assembly from the vehicle. Mount strut assembly into strut compressor.
7.
Compress the strut assembly using manufacturers instructions provided with tool and replace upper strut mount assembly as required.
Torque the strut to strut mount nut to 88-101 lbs. ft. (120-137 Nm).
NOTICE:
Position dimple to match mount orientation as removed in Step 5.
8.
Install the strut assembly into the vehicle Tighten the four (4) upper mount nuts to 33-46 lbs ft (46-62 Nm)
