Sephia LS Sedan L4-1.8L (1998)
18.
Route the BLK wire from the relay through the notch in the bottom cover and under the fuse/relay box mounting.
19.
Secure the eyelet for the black wire under the 12 mm bolt previously removed and install the bolt.
20.
Route the WHT wire from the relay through the side notch in the bottom cover and reattach the fuse/relay box and bottom cover.
21.
Install the fuse/relay box onto the mounting bracket.
22.
Install the 30 amp slow-blow fuse from the kit into the empty socket next to the cooling fan 20 amp slow-blow fuse.
23.
Verify new relay operation as follows:
a.
Temporarily reconnect B+ terminal to C1002 and secure with one nut.
b.
Connect a volt meter between 14 gauge WHT wire and ground.
c.
Turn the ignition switch to the ON position.
Volt meter should indicate approximately 12 volts.
d.
Disconnect the B+ terminal from C1002.
24.
Route the WHT wire along the engine wiring harness, under the large tie-wrap, to the starter solenoid.
* NOTICE
Use tie-wraps included in the kit to secure the wire in place.
