Sephia LS Sedan L4-1.8L (1998)
25.
Disconnect the RED/WHT wire from the starter solenoid.
26.
Connect the WHT wire to the starter solenoid making sure to leave a small loop in the wire between the last tie-wrap and the starter solenoid.
* NOTICE
The loop in the wire will function as a stress relief to prevent damage to the wire and crimp connection.
27.
Install the B+ terminal onto C1002.
28.
Reconnect the negative battery cable.
29.
Start the engine to verify proper operation. After verifying operation, turn the engine OFF.
30.
Install the fuse/relay box cover.
31.
Install the air intake assembly using two bolts and one nut.
32.
Tighten the hose clamp.
33.
Connect the IAT sensor and MAF sensor electrical connectors.
34.
Attach the data link connector.
