Sephia RS Sedan L4-1.6L (1997)
10. Remove the oil seal with a screwdriver.
NOTICE:
-
Tap in until the oil seal installer contacts the case.
-
Coat the oil seal lip with transaxle oil.
11. Tap the new oil seal into the transaxle case with the SST (or equivalent).
12. Replace the driveshaft end clip with a new one.
13. Insert the driveshaft with the end gap of the clip facing upward.
14. Install the joint shaft into the transaxle.
15. Install the joint shaft support bearing mount onto the cylinder block with three bolts.
Tightening torque: 69-83 ft. lbs.