Sorento V6-3.5L (2004)
Brake Bleeding: Service and Repair
ABS (Anti-Lock Brake System)
BLEEDING OF BRAKE SYSTEM
This procedure should be used to insure adequate bleeding and filling of ABS unit, brake lines, master cylinder.
1. Remove the reservoir cap and fill the brake reservoir with brake fluid.
CAUTION: Do not allow brake fluid remain on a painted surface. Wash it off immediately.
NOTE: When bleeding by pressured fluid, do not depress the brake pedal.
Recommended fluid DOT3 or equivalent
2. Connect the clear plastic tube to the wheel cylinder bleeder plug and insert the other end of tube in a half filled clear plastic bottle.
3. Connect Hi-Scan to Data Link Connector located underneath the dash panel.
4. Select and operate according to the instruction on the Hi-Scan screen.
CAUTION: You have to obey maximum operating time (60 sec.) of ABS motor with Hi-Scan to prevent motor pump burnt.
