Sorento 4WD V6-3.3L (2008)
Body Control Module: Description and Operation
OPERATION
1. SEAT BELT WARNING TIMER
(1) When IGN1 ON & SEAT BELT is not being worn, WARNING IND is blinking as cycle of 0.6s and BUZZER is outputting for 6s.
(2) When IGN1 SWITCH is OFF during OUTPUT, SEAT BELT WARNING IND and BUZZER shall stop the output immediately.
(3) When SEAT BELT is wearing during the worn light or alarm output, STOP the output of IND & BUZZER.
(4) In case of IGN1 SWITCH ON, after wearing SEAT BELT and then removing, WARNING IND is blinking as cycle of 0.6s and BUZZER is
outputting for 6s.
(5) When IGN ON during wearing SEAT BELT, don't output IND & BUZZER are not on.
T1 : 6 ± 1 sec.
T2 : 1 ± 0.1 sec,
T3 : 0.3 ± 0.1 sec.
2. REMOTE KEYLESS ENTRY control
Operate LOCK / UNLOCK of DOOR and TAIL GATE GLASS, PANIC by REMOCON.
A. Operate in state of KEY IN SWITCH OUT & ACC SWITCH OFF & IGN1 SWITCH OFF & IGN2 SWITCH OFF.
B. By receiving LOCK, UNLOCK, TAIL GATE GLASS, PANIC signal from transmitter, output LOCK / UNLOCK of DOOR and TAIL GATE
GLASS OPEN, PANIC.
(1) TRANSMITTER LOCK FUNCTION
A. In case of removing IGN KEY from CYLINDER and all Door is CLOSE, when receiving TRANSMITTER LOCK signal, start the
operation of LOCK output and after T3 from the starting point of operation and then checking the state of LOCK SWITCH, ON the output
of HAZARD LAMP for 1s one time.
B. In state of any of DOOR, TAIL GATE, TAIL GATE GLASS is OPEN, when receiving TRANSMITTER LOCK signal, output LOCK
only, don't output HAZARD LAMP.
C. After b), in case of OPEN > CLOSE, ON the output of HAZARD LAMP one time.
D. In state of Driver and Assist(North America ONLY) DOOR LOCK, when receiving TRANSMITTER LOCK signal, output HAZARD
LAMP for 1s one time after re-outputting LOCK.
T1 : 0.5 ± 0.1 sec,
T2 : 1.0 ± 0.2 sec,
T3 : 0.2 ± 0.04 sec.
(2) TRANSMITTER UNLOCK FUNCTION
A. When receiving TRANSMITTER UNLOCK signal, output UNLOCK and ON the output of HAZARD LAMP as cycles of 0.5s and 0.5s
(ON/OFF) two times.
B. In state of Driver and Assist(North America ONLY) DOOR UNLOCK, when receiving TRANSMITTER UNLOCK, ON the output of
HAZARD LAMP as cycles of 0.5s and 0.5s (ON/OFF) two times after outputting UNLOCK.
C. After TRANSMITTER UNLOCK and then there are no inputs of Entering (DOOR, TAIL GATE, TAIL GATE GLASS) OPEN within
30s, lock them automatically and ON the output of HAZARD LAMP for 1s one time. And in case of TRANSMITTER UNLOCK within
30s once more, extend the time for about 30s. (regardless the state of KNOB within 30s)
But, after TRANSMITTER UNLOCK and then insetting KEY within 30s, cancel 30s TIMER. (After the initial TRANSMITTER
UNLOCK without LOCK, HAZARD output, and after keeping the output of ROOM LAMP for 30s, turn out the light 2s)
