Sorento 4WD V6-3.3L (2008)
NOTICE
Support brake calipers by using a suitable wire or hook. Do not let brake calipers hang freely.
8. Remove both rear ABS sensors (C) from rear axle housing.
9. Remove the four (4) rear axle shaft housing/ wheel bearing hub assembly nuts and slide out the rear axle shaft from the rear differential housing
approximately 11 inches. Repeat this procedure for the opposite side.
10. Remove the twelve (12) rear differential carrier mounting bolts, and then remove the carrier assembly.
NOTICE
A transmission jack will simplify the removal and installation procedure of the differential carrier.
