Sorento 4WD V6-3.5L (2011)
6. Install the U-bracket and tighten the two retaining bolts and nuts to 18 lbs. ft. (25 Nm) as shown.
NOTICE
Insert bolts from the outside: Retaining nuts should face in-board as shown in photo.
7. Adjust seat tracks so they are even before installing seat into vehicle.
a) Completed repair is shown in photo; seat is ready to be installed in the vehicle.
8. Ensure door trim panels are covered as during the removal to prevent damage.
a) Properly connect and route wire harness to seat.
