Sorento 4WD V6-3.5L (2011)
1. Remove seat from the vehicle cover the door panel when removing the seat assembly to prevent scratching Use the electronic service information for
step by step seat removal if necessary
2. Use a clean work area with protective covering to prevent soiling or marking of the trim pieces of customer's seat.
Release seat track lever to push seat track rear-ward for ease of access to the working area. Tracks must be reset prior to the seat install.
3. Align the U-bracket over the torsion tube as shown Front edge of bracket should be flush to frame bracket Using a spring loaded center punch, mark
the location that needs to be drilled with a 21/64" drill bit.
Tab reinforcement to the support bracket must be correctly aligned, max gap allowed is 2mm between lower U-bracket and seat frame.
