Sorento 4WD V6-3.5L (2011)
5. With the ignition key ON, turn ON the VCI and GDS tool. Access the GDS vehicle identification number (VIN) screen and configure the vehicle
using the VIN AUTO DETECT Function.
6. Once back at the GDS Main Screen, select ECU Upgrade from the bottom right-hand corner. Next select Auto Mode, and then Engine Perform the
ECM/ECU upgrade in accordance with normal GDS tool ECM/ECU upgrade procedures.
NOTICE
Do NOT attempt to perform a Manual Mode upgrade unless Auto Mode fails. Always follow the instructions given on the GDS tool in either Auto or
Manual mode. See table for Manual Mode passwords.
MANUAL MODE PCM UPGRADE PASSWORDS
7. When the GDS tool reports that the PCM upgrade has been successfully completed, click OK, turn OFF the ignition key, and wait at least 10 seconds
before attempting to start the engine.
8. Check for Diagnostic Trouble Codes using the GDS and erase any DTCs stored, such as ESC and TPMS. Due to CAN BUS, multiple DTC's may be
set during reprogramming.
9. Start the engine to confirm proper operation of the vehicle.
AFFECTED PRODUCTION RANGE
