Spectra L4-2.0L (2004)
Brake Rotor/Disc: Specifications
Front
Brake disc run out
Limit: .......................................................................................................................................................................... 0.03 mm (0.0012 inch) or less
-
If the run out of the brake disc exceeds the limit specification , replace the disc, and then measure the run out again.
-
if the run out does not exceed the limit specification, install the brake disc after turning it 180° and then check the run out of the brake disc
again.
Brake disc thickness
Standard value: .......................................................................................................................................................................... 26.0 mm (1.02 inch)
Limit: ....................................................................................................................................................................................... 24.0 mm (0.945 inch)
-
Thickness variation should not exceed: 0.005mm (0.0002 inch) (circumference) and 0.05mm (0.0020 inch (radius) at any directions.
-
If wear exceeds the limit, replace the discs and pad assembly for left and right of the vehicle.
Rear
Brake disc run out
Limit ............................................................................................................................................................................ 0.03 mm (0.0012 inch) or less
-
If the run out of the brake disc exceeds the limit specification, replace the disc, and then measure the run out again.
-
If the run out does not exceed the limit specification, install the brake disc after turning it 180° and then check the run out of the brake disc
again.
-
If the run out cannot be corrected by changing the position of the brake disc, replace the brake disc.
Rear brake disc thickness Standard value ........................................................................................................................................ 10.0 mm ( 0.39 inch)
Limit .................................................................................................................................................................................................. 8.0 mm (0.315 inch)
-
Thickness variation should not exceed: 0.005mm (0.0002 inch) (circumference) and 0.05 mm (0.0020 inch) (radius) at any directions.
-
If wear exceeds the limit, replace the discs and pad assembly for left and right of the vehicle.
