Spectra L4-2.0L (2004)
Combination Switch: Service and Repair
REMOVAL
Prior to removing of the multifunction switch assembly in vehicles equipped with air bags, be careful to keep the following items.
CAUTION:
-
Never attempt to disassemble or repair the air bag module or clock spring. If faulty, replace it.
-
Do not drop the air bag module or clock spring or allow contact with water, grease or oil. Replace if a dent, crack, deformation or rust are
detected.
-
The air bag module should be stored on a flat surface and placed so that the pad surface is facing upward. Do not place anything on top of it.
-
Do not expose the air bag module to temperatures over 93 °C (200 °F). After deployment of an air bag, replace the clock spring with a new one.
Wear gloves and safety glasses when handling an air bag that has already been deployed.
-
An undeployed air bag module should only be disposed of in accordance with the procedures. mentioned in the Restraints section. When you
disconnect the air bag module-clock spring connector, take care not to apply excessive force to it. The removed air bag module should be stored in
a clean, dry place.
-
Prior to installing the clock spring, align the mating mark and "NEUTRAL " position indicator of the clock spring, and, after turning the front
wheels to the straight-ahead position, install the clock spring to the column switch. If the mating mark of the clock spring is not properly aligned,
the steering wheel may not completely rotate during a turn, or the flat cable within the clock spring may be severed, obstructing normal operation
of the SRS and possibly leading to serious injury to the vehicle's driver.
1. Disconnect the negative (-) battery terminal.
NOTE: Prior to doing any further work after disconnection of the battery cable, wait at least 30 seconds.
2. Remove the 2 bolts (A) holding the air bag module.
3. Disconnect the horn connector and the air bag module connector, and remove the air bag module (B).