Spectra L4-2.0L (2004)
15.
Turn the new terminal in the proper direction and insert into each terminal cavity install the white plastic retainer wrap electrical tape around
harness and connector transition and install the connector and engine cover in reverse order of removal.
^
# 1 Blue with orange wire goes on connector lock side
^
# 4 - White wire goes on connector mounting clip side as shown
16.
Disconnect the hood release cable for better access. Disconnect the PCM harness wire tie clip at the top of the PCM bracket. Disconnect the larger
of the two PCM connectors from the PCM. Pull the connector down to allow access to work.
17.
Cut the small tie strap and remove the tape from the harness above the PCM connector down and away from the harness. Don't pull up on the
cover or the tabs will break.
CAUTION:
Don't pull up on the cover or the tabs will break.
