Spectra L4-2.0L (2004)
-
Set the manual control lever to the neutral position.
-
Loosen the transaxle range switch body mounting bolts and then turn the transaxle range switch body so the hole in the end of the manual control
lever and the hole (cross section A-A in the figure) in the flange of the transaxle range switch body flange are aligned.
-
Tighten the transaxle range switch body mounting bolts to the specified torque. Make sure at this time that the position of the switch body did not
move.
Tightening torque : 10-12 Nm (100-120 kg-cm, 7-8 lb-ft)
-
Gently pull the transmission control cable in the direction of the arrow, and then tighten the adjusting nut.
-
Check that the select lever is in the "N" position.
-
Check that each range on the transmission side operates and functions correctly for each position of the select lever.
