Spectra L4-2.0L (2004)
Clockspring Assembly / Spiral Cable: Service and Repair
REMOVAL
CAUTION:
-
Turn the front wheel to the straight-ahead position when removing/installing the Driver Airbag or Clockspring.
-
Prior to installing the clockspring, set the clockspring on NEUTRAL position and after turning the front wheels to the straight-ahead position,
install the clockspring to the column switch. If the mating mark of the clockspring is not properly aligned, the steering wheel may not completely
rotate during a turn, or the flat cable within the clockspring may be broken obstructing normal operation of the SRS and possibly leading to serious
injury to the vehicle's driver.
-
Never attempt to disassemble or repair the airbag module or clockspring. If faulty, replace it.
-
Do not drop the airbag module or clockspring or allow contact with water, grease or oil. Replace it if a dent, crack, deformation or rust is detected.
-
The airbag module should be stored on a flat surface and placed so that the pad surface is facing upward. Do not place anything on top of it.
-
Do not expose the air bag module to temperatures over 93 °C (200 °F).
-
After deployment of an airbag, replace the clockspring with a new one.
-
Wear gloves and safety glasses when handing an air bag that has been deployed.
-
An undeployed airbag module should only be disposed of in accordance with the procedures mentioned in the restraints section.
-
When you disconnect the air bag module-clockspring connector, take care not to apply excessive force.
-
The removed air bag module should be stored in a clean, dry place.
1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
2. Remove ignition key from the vehicle.
3. Unscrew the DAB mounting bolts (A).