Spectra L4-2.0L (2004)
4. Check the stabilizer link ball joint(A) for rotating torque.
-
If there is a crack in the dust cover, replace it and add grease.
-
Shake the stabilizer link ball joint stud several times.
-
Mount the self - locking nut on the ball joint, and then measure the ball joint rotating torque.
Standard value: 1.7 - 3.2 Nm (17 - 32 kgs-cm, 15 - 27 inch lbs.)
-
If the rotating torque is higher than the upper limit of the standard value, replace the stabilizer link.
-
If the rotating torque is below the lower limit of the standard value, the ball joint may be reused unless it has drag and excessive play.
Installation
INSTALLATION
1. Install the bushing on the stabilizer bar.
NOTE: The distance between the bushing, and the part to which white paint is applied, must continue 10mm outside the vehicle.
2. Install the bracket on the bushing
3. Align and install the bushing with the white paint on the stabilizer bar. After tightening the bolts of the bushing bracket temporarily, install the
bushing bracket on the opposite side.
