Spectra L4-2.0L (2004)
5. After seating the upper and lower ends of the coil spring(A) in the upper and lower spring seat grooves(B) correctly, tighten new self - locking nut
temporarily.
6. Remove the Special Tool(J38402, A - 50).
7. Tighten the self - locking nut to the specified torque.
Tightening torque: 50 - 70 Nm (500 - 700 kgs-cm, 37 - 51 ft. lbs.)
8. Apply grease to the strut upper bearing and install the insulator cap.
CAUTION: When applying the grease, be careful so that it isn't smeared on the insulator rubber.
Inspection
INSPECTION
1. Check the strut insulator bearing for wear or damage.
2. Check rubber parts for damage or deterioration.
3. Compress and extend the piston rod(A) and check that there is no abnormal resistance or unusual sound during operation.
INSPECTION
1. Fully extend the piston rod.
2. Drill a hole on the A section to remove gas from the cylinder.
CAUTION: The gas coming out is harmless, but be careful of chips that may fly when drilling.
