Sportage 2WD V6-2.7L (2009)
INSTALLATION
CAUTION:
-
Be sure to install the harness wires so that they are not pinched or interfering with other parts.
1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
2. Remove ignition key from the vehicle.
3. Install a Curtain Airbag (CAB) on the mounting bracket.
Tightening Torque (CAB Mounting Bolt)
: 6.9 - 8.8 Nm (5.1 - 6.5 lb-ft)
CAUTION:
-
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
4. Install the inflator on the bracket.
5. Connect the CAB connector.
6. Reconnect the battery negative cable.
7. After installing the Curtain Airbag (CAB), confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
