Sportage 2WD V6-2.7L (2009)
4. With a sponge, apply a light coat of body primer to the original adhesive remaining around the flange. Let the body primer dry for at least 10
minutes.
A. Do not apply glass primer to the body, and be careful not to mix up glass and body primer sponges.
B. Never touch the primed surfaces with your hands.
5. Pack adhesive into the cartridge without air pockets to ensure continuous delivery. Put the cartridge in a caulking gun, and run a bead of sealant
(A) around the edge of the quarter fixed glass (B) as shown. Apply the adhesive within 30 minutes after applying the glass primer. Make a slightly
thicker bead at each corner.
6. Install the quarter fixed glass.
7. Let the adhesive dry for at least one hour, then spray water over the rear window and check for leaks. Mark the leaking areas, let the rear window
dry, then seal with sealant. Let the vehicle stand for at least four hours after rear window installation. If the vehicle has to be used within the first
four hours, it must be driven slowly.
8. Reinstall all remaining removed parts.
