Sportage 4WD L4-2.0L (2005)
13. With the rack placed in the center position, attach the yoke plug to the rack housing. Tighten the yoke plug to 15 Nm (1.5 kgf-cm, 11 ft. lbs.).
Loosen the yoke plug approximately from 300 to 600 and tighten the locking nut to the specified torque.
Tightening torque: 50 - 70 Nm (5 - 7 kgf-cm, 37 - 52 ft. lbs.)
14. Tighten the feed tube to the specified torque and in stall the mounting rubber using adhesive.
15. Apply the specified grease to the bellows mounting position (fitting groove) of the tie rod.
16. Install the new attaching band to the bellows.
NOTE: When the bellows are installed, a new band must be used.
17. Install the bellows in position, taking care not to twist it.
18. Fill the dust cover inner side and lip with the specified grease, and fix the dust cover in position with the clip ring attached in the groove of the tie
rod end.
19. Install the tie rods so that the length of the left and right tie rods equals the standard value.
20. Check for total pinion preload.
