Sportage 4WD L4-2.0L DOHC (1996)
1.
While holding the rods in their correct positions, carefully install the new lock assembly into the rear door.
2.
Re-install the three (3) door lock retaining screws and torque to specification.
Tightening Torque: 44 in lb (5 N.m)
CAUTION:
Do not overtighten the retaining screws.
3.
Install the new outside door handle into the rear door, then re-install the two (2) retaining nuts and torque to specification.
CAUTION:
Do not overtighten the retaining nuts.
Tightening Torque: 97 in lb (11 N.m)
4.
Attach the outside door handle rod to the lock assembly.
Notice:
Adjust the outside door handle by lifting the outside door handle rod upward until the bottom of the slot in the rod contacts it's plastic bushing.
Secure the retaining clip by pushing the rod in completely and snapping the lock tab into place.
5.
Attach the door lock knob rod to the door lock knob crank lever and secure the retaining clip, then reattach the door lock knob rod to the black
plastic guide clip.
Notice:
Failure to attach the door lock knob rod to the black plastic guide clip will result in poor inside door lock knob operation.
