Sportage 4WD L4-2.0L DOHC (1996)
switch.
11.
Align the door lock knob with the slot in the rear door trim panel and slide the door panel down onto the rear door.
Notice:
Insure that the rear door trim panel is positioned correctly on the rear door, then press in around the perimeter of the trim panel to re-install the
retaining clips into the rear door
12.
Re-install the retaining screws into the inside door handle and the inside pull handle, then re-install the inside pull handle screw cover.
13.
Re-install the inner door glass weatherstrip by aligning the notch in the weatherstrip with the rear door glass run channel. Beginning at the front
edge of the door, press down evenly on the weatherstrip until it is correctly positioned on the rear door.
14.
Verify the operation of the rear door lock using both the inside and outside door handles.
15.
Verify the manual and power (if equipped) door lock operation.
