Sportage 4WD L4-2.0L DOHC (1996)
7.
Using the Adjustable Adapter Wrench (SST K95B-0001-U), install the Manual Hub Pre-Load Adjusting Nut. Tighten the nut until contact is made
with the front wheel bearing.
8.
Using the Adjustable Adapter Wrench (SST K95B-0001-U) and a Torque Wrench, adjust Front Wheel Bearing Pre-Load.
A.
Using a Foot Pound Torque Wrench, tighten the Pre-Load Adjusting Nut to 12-15 ft.lb.
Notice:
Rotate the wheel by hand while tightening the Pre-Load Adjusting Nut.
B.
Loosen the Pre-Load Adjusting Nut.
C.
Using an Inch Pound Torque Wrench, retighten the Pre-Load Adjusting Nut to the specified torque.
Front Wheel Bearing Pre-Load Adjusting Nut Torque: 30 in. lbs.
CAUTION:
Do NOT exceed the specified torque.
9.
Install the Manual Hub Lock Plate.
Notice:
The aligning holes in the Lock Plate must align with the threaded holes in the Pre-Load Adjusting Nut. If the holes do not align, remove the
Lock Plate and rotate the Adjusting Nut clockwise (tighter) to the nearest alignment position then reinstall the Lock Plate.