Sportage 4WD 2Dr L4-2.0L (2002)
Brake Hose/Line: Service and Repair
(Rear Wheel Service)
Notice: Hydraulic fluid will damage paint. If fluid gets on a painted surface, wipe off immediately.
Removal
1. Loosen the left rear brake line flare nut at the left rear brake assembly and disconnect.
2. Loosen and remove the left rear brake line from the pipe joint.
3. Remove the two bracket bolts and then remove the left rear brake line.
4. Loosen the right rear brake line flare nut from the right rear brake assembly and disconnect.
5. Loosen and remove the right brake line from the pipe joint.
6. Remove the three bracket bolts and then remove the right rear brake line.
7. Remove the nut on the flexible hose.
8. Remove clip and then disconnect flexible hose.
9. Disconnect flexible hose from pipe joint.
10. Remove mounting bolt on pipe joint and remove pipe joint.
Installation