Sportage 4WD 2Dr L4-2.0L (2002)
Brake Light Switch: Service and Repair
BACK-UP LIGHT SWITCH
Removal
1. Disconnect the cable from the negative battery terminal.
2. Raise the vehicle and support it with safety stands.
3. Disconnect the back-up light switch connector.
4. Unscrew and remove the back-up light switch.
Installation
1. Reinstall a new washer onto the back-up light switch.
2. Reinstall the back-up light switch into the transmission.
Tightening torque: 15 ft. lbs. (20 Nm).
3. Reconnect the back-up light switch connector.
4. Lower the vehicle.
5. Reconnect the cable to the negative battery terminal.
