Sportage 4WD 2Dr L4-2.0L (2002)
Turn Signal Bulb: Service and Repair
Rear Combination Light Assembly Bulb (2 Door)
CAUTION: When a removing or installing any electrical units, wiring or electrical connectors, disconnect the negative battery cable to prevent
possible short circuits which could lead to personal injury and/or property damage.
1. Disconnect the negative battery cable.
2. Grasp combination light grille with fingers and pull straight out.
3. Disconnect electrical connector from light assembly.
4. Lift tab at bottom of bulb holder upward to disengage bulb holder from light assembly.
5. With bulb holder disengaged, pull bulb holder carefully forward relative to the vehicle, and remove from the light assembly.
6. Remove the bulb as required from the bulb holder.
7. Install new bulb of proper type.
8. Position bulb holder on light assembly and press to engage with light assembly.
9. Install electrical connector.
10. Install combination light assembly grille.
11. Connect the negative battery cable.
