Sportage 4WD 2Dr L4-2.0L (2002)
Fuel Rail: Service and Repair
Removal
1. Depressurize fuel system. See Releasing Fuel System Pressure.
2. Drain the engine coolant.
3. Disconnect the negative battery terminal.
4. Remove two bolts holding the air intake hose assembly.
5. Loosen the clamp between the throttle body and the air intake duct.
6. Remove the four breather hoses connected to the air intake duct.
7. Disconnect the mass air flow sensor electrical connector.
8. Remove the mass air flow sensor mounting bolts.
9. Loosen the clamp at the air cleaner assembly for the air intake hose.
10. Remove the bolt from the air intake hose bracket.
11. Remove the accelerator cable bracket bolts.
12. Disconnect the accelerator cable.
13. Remove the vacuum hose that goes from the intake manifold to the vacuum pipe.
14. Disconnect the electrical connectors for the throttle position sensor, idle air control valve.
15. Disconnect the two coolant hoses from the throttle body.
16. Remove the clamp and hose from the idle air control valve.
17. Remove the clamp and hose.
