Sportage 4WD 2Dr L4-2.0L (2002)
TACHYCARDIA. FAILURE TO COMPLY WITH THIS WARNING CAN RESULT IN FIRE, NOXIOUS FUMES, SEVERE PERSONAL
INJURY, OR DEATH.
-
AIR BAG MODULE COMPONENTS ARE VERY HOT AFTER DEPLOYMENT. UNITS SHOULD BE DEPLOYED OUTDOORS OR IN AN
OPEN AREA TO PREVENT FIRES. ALLOW COMPONENTS AT LEAST TWENTY MINUTES TO THOROUGHLY COOL. COOLING
MODULES SHOULD BE CONTINUOUSLY MONITORED TO ENSURE HOT COMPONENTS DO NOT CREATE FIRES WITH SPILLED
LIQUIDS OR OTHER DEBRIS. FAILURE TO ALLOW THE UNIT TO COOL COULD RESULT IN BURNS, FIRES OR PERSONAL
INJURY.
-
ALWAYS WEAR RUBBER GLOVES AND SAFETY GLASSES WHEN HANDLING A DEPLOYED AIR BAG AND MODULE.
CAUTION: Storage, transportation, disposal and recycling of air bag module and components must be performed in accordance with all applicable
Federal, State and local regulations including, but not limited to, those governing fire codes, environmental protection, occupational health and safety,
and transportation.
WARNING: FAILURE TO FOLLOW THE FOLLOWING PROCEDURES COULD RESULT IN PERSONAL INJURY OR DEATH.
1. Remove the battery.
2. Wait 10 minutes before proceeding.
3. Disconnect the appropriate air bag module, and remove from the vehicle.
4. Locate the air bag module in an area that will provide protection to personnel when it deploys. An example of a safe deployment site is a stack of
used tires, 6-8 high, with the undeployed air bag module located inside the column of tires.
5. Connect the Air Bag Deployment Tool (K95U-6000-BDY) to the Air Bag Module connector, and position the deployment tool 20 feet away from
the deployment site.
6. Connect the red lead to the positive terminal of the battery.
7. Connect the black lead to the negative battery terminal.
