Sportage 4WD 2Dr L4-2.0L (2002)
4. Use brake fluid to clean inner parts.
Inspection
After cleaning, inspect the following parts:
1. Release cylinder bore and piston for wear.
2. Weak return spring.
Assembly
1. Coat the piston and cups with clean brake fluid.
2. Insert steel ball in cylinder bleeder hole and secure with bleeder screw.
3. Push bleeder cap over bleeder screw end.
4. Insert return spring and piston and cup assembly into cylinder bore.
5. With boot installed on push rod, insert rod into cylinder bore and snap boot in place.
6. Connect flexible hose to the cylinder body. Tighten flexible hose nut to 16 ft. lbs. (22 Nm).
Installation
1. With cylinder push rod in clutch arm detent, attach cylinder to the transmission case with two bolts.
Tighten bolts to 17 ft. lbs. (23 Nm).
2. Install flexible hose onto hydraulic line.
Tighten bolts to 17 ft. lbs. (23 Nm).
3. Mount flexible hose onto retainer strap and install clip.
Notice: Twisting may damage the flex hose.
4. Fill brake fluid reservoir to recommended level.
