Sportage 4WD 2Dr L4-2.0L (2002)
6. Screw lock nut up against wheel hub assembly and using a lock nut wrench, tighten nut to set bearing preload. Use spring scale to measure.
Bearing preload: 10 inch lbs. (1.3 Nm)
7. Put brake rotor on wheel bearing hub bolts and install the two retaining screws.
8. Mount dial indicator with plunger zeroed against brake rotor at 4.7 inch (12 cm) from rotor center.
9. Turn rotor and read dial indicator for runout dimension.
Runout not to exceed 0.004 inch (0.10 mm)
10. Install brake caliper and tighten two bolts.
11. Align the free wheel hub fixed cam key with the lock nut groove and push on fixed cam assembly. Apply grease to both sides of the snap ring.
12. Put spacer on the axle, then using suitable snap ring pliers, install axle retainer snap ring.
13. Apply sealant to free wheel hub body mounting surface
14. Install and tighten, in two passes, six bolts in the order shown.
First pass: Tighten hub mounting bolts to 19 ft. lbs. (25 Nm).
