Sportage EX 2WD L4-2.0L (1997)
11. Loosen the radiator drain plug and drain the engine coolant into a suitable container.
12. Tighten the radiator drain plug.
13. Remove the purge solenoid valve vacuum hose from the dynamic chamber.
14. Disconnect the electrical connector from the throttle position sensor.
15. Disconnect the electrical connection for the idle air control valve by pulling the wire clip out.
16. Remove both heater hoses from the pipes.
17. Remove the engine-to-body ground bolt attaching the ground wire to the intake manifold assembly.
18. Remove the two heater hoses from below the throttle body.
Fig. 4 Brake Booster Replacement
19. Remove the brake booster vacuum line.
20. Remove the cruise control vacuum hose.
21. Remove the vacuum hose from the fuel pressure regulator.
22. Remove the vacuum hose from the EGR valve.
23. Disconnect the electrical connector from the EGR solenoid valve on the intake manifold.
24. Remove the two dynamic chamber support brackets and the bolts.
