ADDITIONAL HEATER REMOTE CONTROL – Initialization procedure - Service Manual update

Service news 50.04.03

ADDITIONAL HEATER REMOTE CONTROL

Initialization procedure - Service Manual update

In advance of the Service Manual update we wish to notify you that the initialization procedure described below must be carried out for each new remote control:

• With the ignition key in the OFF position, disconnect the negative battery lead (this operation is required to prepare the system memory to receive the new code);
• Connect the negative battery lead and, within 5 seconds, press the OFF button on the remote control (A - Fig. 1) pointing it at the vehicle; the LED (B) coming on indicates that the signal has been sent to the receiver;
• Check the result of the procedure by activating the heater using the ON button.

Fig. 1

This procedure is necessary each time the remote control which comes with the vehicle (already initialized in production) is replaced with a new one (not initialized) from the Parts Dept. or when additional new remote controls are ordered.