Engine oil delivery pipe to turbocharger - r + r

Operation 1084B40 · Engine oil lubrication circuit

1.3 JTD

Removing

Make sure that the ignition key is in the OFF position; then disconnect the battery negative (-) terminal.

1. Disconnect the electrical connection from the air flow meter.

2. Loosen the band and disconnect the the turbocharger air inlet sleeve from the rigid pipe, air flow meter side.

1. Remove the air filter (1a) complete with air flow meter (1b) by releasing from the underlying pins and then from the rear fastenings.

1. Undo the connectors (1a) and remove the engine oil supply pipe to the turbocharger (1b).

Refitting

1. Connect the engine oil supply pipe to the turbocharger (1a) and secure by tightening the connectors (1b) to the recommended torque.

Replace the copper washers for the connectors.

Replace the air filter, complete with air flow meter, in its housing.

Connect the air intake sleeve to the turbocharger, air flow meter side, and tighten the band.

Connect the electrical connection to the air flow meter.

Connect the negative (-) battery terminal.