Workshop Manuals Factory service & repair

Lancia Ypsilon Factory Service Manual (2003-2011)22 · Fault diagnosis

22 · Diagnostics

Bonnet wind noise

Make: Lancia
Model: Ypsilon Factory Service Manual
Year: 2003–2011
Section: Wind noise › Bonnet wind noise

‹ Prev Wind noise from the front doors Next › Windscreen wind noise

Fault diagnosisBonnet wind noise

BONNET WIND NOISE

With the vehicle moving, there is noise coming from the front of the passenger compartment.

0	PRELIMINARY CHECKS	All OK	Problems met	Operation
		Results of the tests
	Preliminarily check that the bonnet is properly closed Check that the noise is actually coming from the bonnet lid by carrying out the test for locating the noise.	Continue to Step 1	The wind noise comes from the front dooor	Continue according to the instructions in See table T01 WIND NOISE FROM THE FRONT DOORS
			The wind noise comes from the windcreen	Continue according to the instructions in See table T06 WINDSCREEN WIND NOISE
			The noise is coming from the lower area of the passenger compartment	Continue according to the instructions in See table T10 PASSENGER COMPARTMENT WIND NOISE, LOWER AREA
			The wind noise comes from the sun roof	Continue according to the instructions in See table T20 WIND NOISE FROM THE SUN ROOF
			The noise is coming from the rear area	Continue according to the instructions in See table T25 WIND NOISE FROM THE REAR AREA
1	CHECK LOCATION OF NOISE FROM BONNET LID	All OK	Problems met	Operation
	Carry out the detailed test for locating noise from the bonnet lid ( See Test 7025A Location of bonnet wind noise) and identify the area where the noise is coming from.	Continue to Step 2	The noise is coming from the side of the bonnet	Check the foam blocks at the point where the bonnet and wings fit together at the rear. Check the condition of the wind seal and make sure it is properly fitted ( Op. 7025A62)
		Continue to Step 2	The noise is coming from the front of the bonnet	Check the condition of the front seal and make sure it is properly fitted ( Op. 7025A62)
2	FLAME DAMPER CHECK	All OK	Problems met	Operation
	Check the flame damper partition. In particular, ascertain: The plugs are fitted; The plugs are correctly fitted; the rubber cable covers are fitted correctly the sealing is efficient correct fitting	Continue to Step 3	Flame damper partition faulty	Renew the flame damper partition
3	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists

‹ Prev Wind noise from the front doors Next › Windscreen wind noise

Parts & tools for this job For 2003 Lancia Ypsilon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.