Wipers and washers

WIPERS AND WASHERS

DESCRIPTION

The front windscreen wipers are controlled from the column switch and operate when the ignition switch is in position ’II’. The wipers have 2 speed settings, along with a flick wipe and single wipe facility. An intermittent wipe function and programmed wash wipe facility is controlled by the front wiper delay unit.

Moving the wiper switch down from the off position initiates the intermittent wipe function. Moving the wiper switch up one position from the off position, operates the wipers at slow speed. Moving the wiper switch up two positions from the off position, operates the wipers at fast speed. Pushing the wiper switch up from the off position, not allowing it to latch, and then releasing it causes the wipers to perform a single wipe cycle at slow speed. Pushing and holding the wiper switch up from the off position, not allowing it to latch, causes the wipers to operate at slow speed until the wiper switch is released.

Pressing the end of the wiper switch, initiates the programmed wash wipe sequence. The windscreen washers operate while the switch is pressed and the wipers continue to operate for a number of cycles after the switch is released.

The rear screen wiper and wash facilities are controlled by a switch mounted on the dash panel. Pressing the switch causes the rear washer to operate until the switch is released. The rear wiper does not operate automatically with the rear wiper. Turning the switch clockwise causes the rear wiper to operate until the switch is turned back to the off position.