Discovery II
DOORS
REPAIRS
76-1-7
Regulator and motor - front and rear
door glass
$% 76.31.45
Remove
1. Remove door trim casing.
2. Carefully release water shedder from door.
3. Lower glass and remove 2 bolts securing door
glass to regulator.
4. Raise glass and secure with a suitable wedge.
5. Disconnect multiplug from glass lift motor.
6. Front door: Remove 6 bolts securing glass
regulator assembly to door.
7. Rear door: Remove 4 bolts securing glass
regulator assembly to door.
8. Manoeuvre regulator through access hole at
bottom of the door.
9. Remove 3 Torx screws securing glass lift
motor to regulator and remove motor.
Refit
1. Clean mating faces of regulator and motor.
2. Fit glass lift motor to regulator and tighten 3
Torx screws to 5 Nm (3.7 lbf.ft).
3. Position regulator in door. Fit bolts securing
regulator to door and tighten to 6 Nm (4.4
lbf.ft).
4. Connect multiplug to glass lift motor.
5. Remove wedge holding glass and position
glass to regulator.
6. Secure glass to regulator with bolts and tighten
to 6 Nm (4.4 lbf.ft).
7. Fit water shedder to door.
8. Fit door trim casing.
