Discovery II
ENGINE - V8
REPAIRS 12-2-39
Switch - oil pressure
$% 12.60.50
Remove
1. Release fixings and remove battery cover.
2. Disconnect battery earth lead.
3. Raise front of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
4. Remove fixings and remove underbelly panel.
5. Disconnect multiplug from oil pressure switch.
6. Position container below switch to catch oil
spillage.
7. Remove oil pressure switch and discard
sealing washer.
Refit
1. Clean oil pressure switch threads.
2. Fit new sealing washer to switch.
3. Fit oil pressure switch and tighten to 15 Nm (11
lbf.ft) .
4. Connect multiplug to oil pressure switch.
5. Fit underbelly panel and secure with fixings.
6. Remove stand(s) and lower vehicle.
7. Connect battery earth lead.
8. Fit battery cover and retain with fixings.
9. Top up engine oil.
Cooler - engine oil
$% 12.60.68
Remove
1. Release fixings and remove battery cover.
2. Release fixings and remove cooling fan cowl.
3. Remove front grille.
4. Remove 6 scrivets and remove LH and RH air
deflectors from front panel.
5. Remove nut and move LH horn aside.