Discovery II
EXTERIOR FITTINGS
76-2-12 REPAIRS
Bumper assembly - front
$% 76.22.08
Remove
1. Remove 14 screws securing LH and RH wheel
arch liner extensions to wheel arch liners and
bumper valance and remove extensions.
Note: 18 screws are used on 03 MY onwards.
2. Disconnect multiplugs from fog lamps.
3. Remove 2 nuts securing bumper valance side
mountings to body.
4. Remove 4 nuts securing bumper to crush cans
and remove bumper from body.
5. Remove 3 screws securing bumper to front
cross bar.
6. Models with headlamp wash: Position
container to collect screen washer fluid and
disconnect hose from headlamp washer pump.
Refit
1. Models with headlamp wash: Connect hose
to headlamp washer pump. Refill washer
reservoir with fluid.
2. With assistance position bumper to body.
3. Fit and tighten 3 screws securing bumper to
front cross bar.
4. Tighten nuts securing bumper to crush cans to
13 Nm (10 lbf.ft).
5. Tighten nuts securing bumper to side
mountings to 13 Nm (10 lbf.ft).
6. Connect multiplugs to fog lamps.
7. Fit wheel arch liner extensions and secure with
screws.