Discovery II
EXTERIOR FITTINGS
76-2-4
REPAIRS
Refit
1. Clean front wing body mounting brackets.
2. Fit and secure the front wheel arch finisher to
the front wing.
3. Position lower support bracket to the front wing,
fit nut and tighten to 8 Nm (6 lbf.ft).
4. Position front wing to body, fit bracket and bolts
but do not tighten at this stage.
5. Check and adjust alignment of the front wing to
the bonnet and door.
6. Tighten the front wing retaining bolts to 8 Nm (6
lbf.ft).
7. Fit bonnet sealing rubber to the front wing
flange.
8. Fit bolt securing lower support bracket to the
body and tighten to 8 Nm (6 lbf.ft).
9. Fit nut securing sill finisher to the front wing
lower support bracket and tighten to 8 Nm (6
lbf.ft).
10. Fit bolt securing front wing to the front support
bracket and tighten to 8 Nm (6 lbf.ft).
11. Fit side repeater lamp to the front wing and
connect the multiplug.
12. Fit front wheel arch liner extension panel to the
front bumper and secure with screws.
13. Fit and tighten screw securing front wheel arch
liner extension panel to the inner wing.
14. Fit the front wheel arch liner.
15. Fit the headlamp assembly.
Rear folding step
$% 76.10.41
Remove
1. Remove 2 bolts securing step and damper
assembly to chassis.
2. Remove step and damper assembly.
3. Remove 2 patch lock nuts securing damper to
step and discard nuts.
4. Remove damper from step.
Refit
1. Fit damper to step and secure with new patch
lock nuts. Tighten nuts to 17 Nm (13 lbf.ft).
2. Position step and damper assembly to chassis
and secure with bolts. Tighten bolts to 45 Nm
(33 lbf.ft).