Discovery II
FRONT SUSPENSION
REPAIRS
60-33
Wheel hub
$% 60.25.01
Remove
1. Release ABS sensor harness grommet from
inner wing valance and disconnect multiplug.
2. Raise front of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
3. Remove road wheel.
4. Pull ABS sensor harness through aperture into
wheel arch.
5. Release harness from brackets on inner wing
valance, suspension turret and front hub.
6. Release stake from drive shaft nut.
7. With assistance, remove drive shaft nut.
Discard the nut.
8. Remove front brake disc.
9. Remove 4 bolts securing wheel hub to steering
knuckle.
10. Release wheel hub from steering knuckle, then
remove wheel hub and drive shaft assembly
from axle.
CAUTION: Do NOT remove the ABS sensor
from the hub. The hub and the sensor are
supplied as an assembly.