Discovery II
INTERIOR TRIM COMPONENTS
REPAIRS
76-3-7
17. Remove console.
NOTE: Do not carry out further dismantling if
component is removed for access only.
18. Remove 4 screws securing storage bin lid to
console and remove lid.
19. Release cigar lighter body from console and
remove.
Refit
1. Fit and secure cigar lighter body to console.
2. Fit lid to console and secure with screws.
3. Fit console.
4. Connect multiplug and bulb to cigar lighter.
5. Fit centre console to fascia.
6. Fit 2 bolts securing rear of console to
transmission tunnel.
7. Connect multiplugs to seat switches.
8. Fit switches to console.
9. Move handbrake to lowered position.
10. Fit cable to handbrake and secure with clevis
pin and clip.
11. Fit handbrake gaiter to console.
12. Fit bolts securing forward edge of console to
transmission tunnel.
13. Models with veneer trim: Position veneered
console cover and connect multiplugs to switch
pack. Fit cigar lighter element and secure
veneered console cover to console.
14. Models with base trim: Connect multiplugs to
switch pack, fit switch pack to console and
secure with screws.
15. Models with base trim: Fit cover plate to
switch pack, and rubber mat to console.
16. Fit transfer box gaiter and knob to lever.
17. Secure transfer box gaiter to console.
18. Connect multiplug to selector panel, fit and
secure panel to centre console.
19. Fit spacer and knob to gear selector lever.
20. Models from 03MY:Fit both centre console
cup holders.
Console - centre - manual models
$% 76.25.01
Remove
1. Release clips securing gear lever gaiter to
centre console and remove knob and gaiter.
2. Models from 03MY:Remove both centre
console cup holders.
3. Release clips securing transfer box lever gaiter
to centre console and remove knob and gaiter.