Discovery II
LIGHTING
ADJUSTMENTS
86-2-1
LIGHTING
ADJUSTMENTS
Headlamps beam alignment - up to 03MY
$% 86.40.17
Check
1. Ensure vehicle is unladen and tyres are at
correct pressures.
2. Models with SLS: Ensure vehicle is at
standard ride height.
3. Models with headlamp levelling: Ensure
headlamp levelling switch is set to '0'.
4. Align suitable beam setting equipment to
headlamp.
5. Switch headlamps on and measure main beam
settings. Beam must be 1.4% below the
horizontal and parallel to the vehicle centre line.
If necessary, adjust headlamp to get correct
beam settings.
6. Align beam setting equipment to 2nd headlamp
and repeat check.
7. Switch off headlamps and remove beam setting
equipment.
Adjust
1. For RH headlamps: Release fixings and
remove battery cover
2. Remove headlamp access cover.
3. Turn vertical adjuster as necessary to get
correct beam setting. Use a 7 mm Allen key for
models with headlamp levelling, or a 10 mm
spanner for models without headlamp levelling.
4. Turn horizontal adjuster as necessary to get
correct beam setting. Use a 10 mm spanner.
5. Fit headlamp access cover.
6. For RH headlamp adjustment: Fit battery
cover and secure fixings.